Installation Method of PC Polycarbonate Embossed Sheet

- Storage Requirements Store in a cool and dry place. Do not expose to direct sunlight (otherwise the protective film cannot be peeled off), avoid rain, and do not stack directly on cement ground.
- Selection of Sealant Neutral silicone sealant shall be used. Acidic or alkaline glass glue shall not be used as a substitute.
- Screw Fixing Rivets are not allowed for installing the embossed sheet. For curved embossed sheet projects, drilling screws on the panel is prohibited, as internal stress will cause cracking of the embossed sheet. For low-slope embossed sheet applications, screw fixing on the panel is also not recommended. If screw fixing is mandatory, special waterproof gaskets must be fitted for each screw, and pre-drilling (enlarged holes) is required at every screw position. The diameter of the drilled hole shall be 4 mm larger than that of the screw to prevent tearing of the sheet due to thermal expansion and contraction.
- Service Environment Embossed sheets are sensitive to acids and alkalis. They shall not be in direct contact with cement brick walls, nor used in environments containing acidic or alkaline substances and gases.
- Protective Film The protective film prevents scratches on the embossed sheet surface during transportation and installation. It must be removed immediately after construction is completed.
- Cutting High-speed fine-tooth circular saws can be used for cutting with a slow feeding speed. Portable electric saws are also acceptable. In all cases, support the area near the cutting position and clear away dust and debris generated during cutting.
- Cleaning
- Rainwater self-cleaning is normally sufficient. Diluted household cleaning agents can be used for local small-area cleaning.
- Ensure the cleaning agent contains no corrosive agents or organic solvents.
- Avoid dry wiping, as dust particles may scratch the sheet surface.
- Water guns can be adopted for large-area flushing.








